If using with single-color Ultralux buttons, order the 6.3mm connector size. Ideal for connecting all positive connections of LEDs to one of the “+” pins on the board. Pre-made harness with 32 x 6.3mm or 4.7mm connectors fitted. Use for the channel (negative) connections of individual LEDs. If required, these can be cut and shortened, which requires a new crimp terminal to be fitted. The other ends have 6.3mm or 4.7mm push-on terminals. These are 600mm long wires which push into the housings, above. See the Ultralux product page for more info. Illuminated joystick handle for Servostik and J-Stik. The following are available in our online store: The pins labeled A1-A6, PR, NX and GND are for future customized OEM versions of the board and are not used in the standard version. These have built-in wiring and connectors available in 2 lengths. Note that if using Ultimarc Ultralux RGB pushbuttons, no additional connectors nor wiring is required. The picture below shows a schematic representation of three LEDs connected to channels 31-33 You can daisy-chain multiple LED + connections and connect to one + pin. Note it does not matter which of the “+” pins you use as they are all connected together on the board. Other harnesses and connectors available.Įach LED must have its negative connection (cathode) connected to one of the numbered pins 1-64.Įach LED must also have its positive (anode) connection connected to one of the supply pins marked “+”. Our Ultralux RGB pushbuttons simply plug in. Extensive software support including test application, Software Development kit for adding support to your own programs, and LedBlinky third-party software. ![]()
0 Comments
Leave a Reply. |